Such scary, much wow!
CNC machined, black oxide coated all steel rails for use with Glock slides for your 0% build.
These are steel inserts for those who wish to make frames from scratch and want stronger steel slide rails regardless of frame material. These are like the rails you get with a P80 kit, just not cast & stamped sheet metal.
Manufactured to a higher standard from billet steel, these wont crack, fatigue, or wear abnormally. 100% smooth drop in reliable function from the first round to the 5000th and beyond..
One size fits all G19 width slides: G26, G26L, G19, G17, G34, G17L, etc. (Will not fit G43 width slides)
This rail kit is NOT for the P80 frames.
Design and build your own frame! Custom grip to YOUR hand or foot? G26L? PDW? SpaceGat? CatGat? Tactastic Oper9er Glockpup? Sharks with fricken Glockerbeams? Whatever! Also many publicly available designs to start from.
These rails can be removed and transferred for use with new designs, different frame size, new features, improvements, etc.
What is included in this kit:
-Machined Glock rails
-5x buttonhead screws
-5x countersunk screws
-2x roll pins
-1x bullet tube of Vibratite
Additional Features (technical mumbojumbo)
These rails have undercuts that compensate for slide tolerance variation from different manufacturers, or compensate so frame size variation, eliminating the potential for slide rub/drag or the need for fitting.
The radii aren't just to look pretty, they are there so sharp corners don't potentially impact the internal radius of the slide slot.
Extra clearances are included that allow these rails to be used for smaller frames (G26) while still clearing hardware and allowing full slide travel. No special rails needed for the G26.
These come with all necessary mounting hardware: Both types of black screws (button head & countersunk), roll pins and extras of each!
Specially sourced harder-to-find 7mm length hardware so you dont have to modify the screws to clear the trigger mechanism.
(Most 2.5mm screws come in even lengths, i.e. 8mm requires trimming, and 6mm is too short)
What else you'll need:
Complete Glock slide assembly of your choice.
The whole frame, that you build. This is like a 0% build. You can print, machine, cast, whittle, etc.
Lower parts kit:
(G19 and G26 based designs use a G26 locking block, and standard LPK from either. You can trim down the ears of a G19 locking block if that's what you have)
(G17 based designs use G17 LPK and locking block)
There are many frame CAD files out there that these will drop into however obviously not all. All BTB stuff is good to go, FMDA G26 is no go.
Please observe all local, state, federal and natural laws that apply to you.
Credit for the origins of this project goes to Ivanthetroll over at DetDisp. The credit for this revision is to 304machining.